GM Service Manual Online
For 1990-2009 cars only

Circuit Description

The Continuously Variable Road Sensing Suspension (CVRSS) module performs internal checks of all internal program and data memory spaces. Additionally, various internal functions and data communications are monitored for valid operation.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

    â€¢ The DTC is set when the CVRSS module detects an internal hardware fault.
    â€¢ The fault is detected during three consecutive ignition cycles, or during the same ignition cycle after clearing the DTC with the scan tool.

Action Taken When the DTC Sets

Depending upon which internal functions are affected by the fault condition, the CVRSS module will take one of two sets of actions:

    â€¢ If the fault condition allows continued output operation, the system will enter a Speed Dependent Damping mode, in which all four corners of the vehicle are concurrently driven by a fixed PWM duty cycle, which increases as a function of vehicle speed. The SERVICE SUSPENSION SYS will be displayed.
    â€¢ If the fault is more severe, the control module will disable ALL dampers by commanding 0 % PWM duty cycle, disabling the damper switched battery circuit, and sending a message to the Powertrain Control Module (PCM) to limit vehicle speed. The SPEED LIMITED TO XXX and SERVICE SUSPENSION SYS messages will be displayed.

Conditions for Clearing the MIL/DTC

    â€¢ The scan tool can be used to clear the DTC.
    â€¢ The DTC is saved as history when the CVRSS module no longer senses the hardware fault and the ignition is cycled OFF and ON. The DTC will clear if the fault does not return after 50 consecutive ignition cycles.

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. This step checks to see if the fault condition is active or intermittent.

  2. This step checks to see if a history DTC C0550 will return.

  3. This step checks to see if the vehicle has a known intermittent problem.

Step

Action

Yes

No

1

Did you perform the Road Sensing Suspension Diagnostic System Check ?

Go to Step 2

Go to Diagnostic System Check - Road Sensing Suspension

2

Inspect for DTC C0550.

Is DTC C0550 displayed as a CURRENT fault (not a HISTORY fault)?

Go to Step 5

Go to Step 3

3

  1. Use the scan tool in order to clear the DTCs .
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC reset?

Go to Step 5

Go to Step 4

4

Has this vehicle been serviced for DTC C0550 previously?

Go to Step 5

Go to Step 6

5

Important: Perform the set up procedure for the CVRSS module.

Replace the CVRSS module. Refer to Electronic Suspension Control Module Replacement .

Did you complete the replacement?

Go to Step 6

--

6

  1. Use the scan tool in order to clear the DTCs .
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.

Does the DTC reset?

Go to Step 2

System OK