GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 2001 🢒 Seville - RHD 🢒 Body and Accessories 🢒 Body Front End 🢒 Front Bumper Fascia Replacement

Removal Procedure
  1. Open the hood.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the front air deflector. Refer to Front Air Deflector Replacement in Body Front End.
  4. Remove the fascia extensions. Refer to Front Bumper Fascia Extension Replacement in Body Front End.

    5. Object Number: 105161 Size: SH
  5. Remove the fasteners (1) securing the front bumper fascia (3) to the front fender (2).

    6. Object Number: 105159 Size: SH
  6. Remove the fasteners (2) securing the stud plate (3) on the front bumper fascia (4) to the front fender (1).

    7. Object Number: 105162 Size: SH
  7. Remove the lower push-in retainers (3) securing the front bumper fascia (1) to the front impact bar (4).
  8. Remove the upper push-in retainers (2) securing the front bumper fascia (1) to the front impact bar (4).
  9. Remove the front bumper fascia (1) and the front energy absorber (5) from the front impact bar (4).

Installation Procedure

    Object Number: 105160 Size: SH
  1. Verify that the push nuts (3) are intact and secure in the bottom of the front fender (2).

    2. Object Number: 105162 Size: SH
  2. Position the front bumper fascia (1) and the front energy absorber (5) to the front impact bar (4).
  3. Install the push-in retainers (3) to the upper front bumper fascia (1) to the front impact bar (4).
  4. Install the push-in retainers (2) to the lower front bumper fascia (1) to the front impact bar (4).

    5. Object Number: 105159 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the fasteners (2) in order to secure the stud plate (3) on the front bumper fascia (4) to the front fender (1).

    6. Tighten
    Tighten the fasteners to 9 N·m (80 lb in).


    Object Number: 105161 Size: SH
  6. Install the fasteners (1) in order to secure the front bumper fascia (3) to the front fender (2).

    7. Tighten
    Tighten the fasteners to 9 N·m (80 lb in).

  7. Install the front wheelhouse extensions. Refer to Front Bumper Fascia Extension Replacement in Body Front End.
  8. Install the front air deflector. Refer to Front Air Deflector Replacement in Body Front End.
  9. Lower the vehicle.
  10. Close the hood.