Schematic Reference: Exterior Lights Schematics

1

Did you perform the Lighting Systems Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Lighting Systems

1. Turn ON the ignition, with the engine OFF.
2. Place the headlamp switch in the PARK position.
3. Place the turn signal switch in the LEFT TURN position.
4. Place the turn signal switch in the RIGHT TURN position.
5. Place the turn signal switch in the CENTER position.

Did the cornering lamps operate properly?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

Do the park lamps operate properly?

Go to Step 4

Go to Park Lamps Inoperative

1. Turn OFF the ignition.
2. Disconnect the turn signal switch.
3. Turn ON the ignition, with the engine OFF.

Does the cornering lamp remain illuminated?

Go to Step 6

Go to Step 5

Inspect for poor connections at the harness connector of the turn signal switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 8

Go to Step 7

Repair a short to battery positive voltage in the appropriate cornering lamp supply voltage circuit. Refer to Wiring Repairs in Wiring Systems

Did you complete the repair?

Go to Step 8

--

Replace the turn signal switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle in Steering Wheel and Column-Tilt.

Did you complete the replacement?

Go to Step 8

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2