Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle Power Tilt and Telescope
- Install the turn signal and multifunction switch assembly. Install the 2 pan head tapping screws.
- Install the blue (1), black (2), and gray (3) connectors of the turn signal and multifunction switch assembly.
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 7 N·m (62 lb in).
Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle Manual Tilt
- Install the turn signal and multifunction switch assembly (1).
- Install the 2 pan head tapping screws.
- Route the wire harness assembly along the steering column jacket assembly.
- Install the blue (1), black (2), and gray (3) connectors of the turn signal and multifunction switch assembly.
- Pop the wire harness assembly (1) into the wire harness strap (2).
- Install the 2 wire harness straps (2). Install the wire harness strap (2) to the steering column tilt head assembly (1).
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
Important: The electrical contact must rest on the turn signal cancel cam assembly.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 7 N·m (62 lb in).
Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle Right Hand
- Install the turn signal and multifunction switch assembly (1). Install the 2 pan head tapping screws (2).
- Install the blue (1), black (2), and gray (3) connectors of the turn signal and multifunction switch assembly.
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 7 N·m (62 lb in).
