GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 104758  Size: SH
  1. Disconnect the accelerator control cable (2) from the accelerator controls bracket (3).

  2. Object Number: 154786  Size: SH
  3. Disconnect the accelerator control cable (3) from the throttle body lever (2).

  4. Object Number: 104758  Size: SH
  5. Disconnect the accelerator control cable (2) at the retainer (1) on the bulkhead.

  6. Object Number: 154846  Size: SH
  7. Remove the left closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in instrument Panel, Gauges, and Console.
  8. Disconnect the accelerator control cable (1) at the accelerator controls pedal (3).
  9. Squeeze the accelerator control cable (1) cover tangs and push the accelerator control cable through the bulkhead.
  10. Remove the accelerator control cable.

Installation Procedure

Notice: In order to prevent possible interference and damage, flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2 in) of moving parts, unless the routing is positively controlled.


    Object Number: 154786  Size: SH
  1. Install the accelerator control cable (3) at the throttle body lever (2).
  2. Important: Accelerator control cable must be routed through groove in throttle body lever and seated securely.

  3. Install the accelerator control cable (3) at the accelerator controls cable bracket (1).

  4. Object Number: 104758  Size: SH
  5. Route the accelerator control cable (2) over the brake master cylinder and through the bulkhead.
  6. Secure the accelerator control cable (2) at the retainer (1) on the bulkhead.

  7. Object Number: 154846  Size: SH
  8. Install the accelerator control cable (1) at accelerator controls pedal (3).
  9. Important: Check for complete throttle opening and closing positions by operating accelerator controls pedal. Also check for poor carpet fit under the accelerator controls pedal. Throttle should operate freely without bind between full closed and wide open throttle.

  10. Install the left closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in instrument Panel, Gauges, and Console.