Circuit Description
The RKE module runs this test every time the module processes a message from the transmitters.
Conditions for Setting the DTC
The module will set this DTC if it receives a transmission from a out of sync transmitter.
Action Taken When the DTC Sets
Stores a DTC B3108 in the RKE current memory.
No driver warning message will be displayed for this DTC.
Conditions for Clearing the MIL/DTC
The RKE module will clear this DTC after a valid transmission is received from a transmitter.
Diagnostic Aids
This DTC will stay in memory as current until it receives a valid transmission from the RKE transmitters then history until cleared. Obtain all transmitters from the customer and synchronize the transmitters.
Test Description
The numbers below refer to steps on the diagnostic table:
-
Perform the Remote Keyless Entry Daignostic System Check before diagnosing DTC 3108.
-
This repair is to check for known good transmitter synchronization.
-
This repair requires the customer's additional transmitters.
-
This step requires battery replacement with battery type 2032.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Were you sent here from Remote Keyless Entry Diagnostic System Check? | -- | ||
2 | Has the transmitter been synchronized? | -- | ||
3 | Synchronize transmitter. Refer to Transmitter Synchronization . Is the synchronizing complete? | -- | -- | |
4 | Test with a known good transmitter to determine battery quality in suspect transmitter. Does the transmitter function properly? | -- | ||
5 | Replace the transmitter battery with known good battery. Refer to Transmitter Battery Replacement . Does the transmitter function properly? | -- | ||
6 |
Does the scan tool read correct transmitter used and function requested? | -- | ||
7 | Replace the RKE module. Refer to Remote Control Door Lock Receiver Replacement . Is the repair complete? | -- | -- | |
8 | Replace the transmitter. Refer to Transmitter Replacement . Is the repair complete? | -- | -- |
