Tools Required

J 35917 Ball Joint Remover

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement in Disc Brakes.
4. Using J 35917 press out the wheel stud.
5. Remove the wheel stud at the inner most notch in the knuckle on the caliper side of the steering knuckle.

1. Install a new wheel stud .
2. Using washers and a wheel nut, pull the wheel stud in position.
3. Install the brake rotor. Refer to Rear Brake Rotor Replacement in Disc Brakes.
4. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
5. Lower the vehicle.