Important: If the sunroof motor is the only part being serviced, follow the power
sunroof motor replacement procedure for the sunroof motor to sunroof glass
timing. Refer to
Power Sunroof Motor Replacement
.
A new replacement power sunroof motor is set to the fully closed and
flush position at the factory.
- Remove the sunroof glass
panel. Refer to
Sunroof Glass Panel Replacement
.
- Fabricate a gage (2) 46.8 +/- 0.5 mm
(1.84 in) wide (A).
A piece of thick paper will work.
- Set the gage into the track near the rear of the opening between
the move driver slide (1) and the bracket.
- Move the driver slide fore or aft in order to get the proper setting.
- Repeat steps 3 and 4 for the other side.
- Install the sunroof motor. Refer to
Power Sunroof Motor Replacement
.
- Install the sunroof glass panel. Refer to
Sunroof Glass Panel Replacement
.
- Operate the sunroof through all functions to ensure proper operation.