For 1990-2009 cars only
Removal Procedure
- Remove the driver side insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
- Disconnect the upper switch electrical connector.
- Twist the upper brake release switch (5) counterclockwise. Remove the brake release switch.
Installation Procedure
- Connect the upper brake release switch (5) electrical connector.
- Install the upper brake release switch (5) into the upper retainer (6). Install the brake release switch connector in the 6 o'clock position.
- Adjust the brake release switch. Refer to Brake Release Switch Adjustment .
- Install the driver side insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
Notice: Proper stoplamp switch adjustment is essential. Improper stoplamp switch adjustment could cause brake drag and excessive brake lining wear.
Important: When the brake pedal switches are installed, the brake pedal must remain in the full up or at rest position, or damage to the brake system and/or switch misadjustment can occur.
Important: The brake release switch assembly and the stoplamp switch assembly must not be adjusted until after the brake booster pushrod is assembled to the brake pedal assembly. Incorrect adjustment can cause the cruise control system to malfunction.
