Tools Required

J 39400 Electronic Halogen Leak Detector

1. Recover the refrigerant from the system. Refer to Refrigerant Recovery and Recharging .
2. Remove the service fitting from the line.

1. Lubricate the O-ring with 525 refrigerant oil.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the service fitting to the line.

Tighten
Tighten the service fitting to 12 N·m (9 lb ft).

3. Recharge the refrigerant system. Refer to Refrigerant Recovery and Recharging .
4. Leak test the fittings of the repaired or reienstalled compenet using J 39400 .