1. Remove the electrical connector (1) from the idle air control valve (4).



2. Remove the idle air control valve attaching screws (2) from the idle air control valve (1).



3. Remove the idle air control valve from the throttle body.
4. Remove the idle air control valve O-ring.

1. Install the new idle air control valve O-ring.



2. Install the idle air control valve (1) into the throttle body.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the idle air control valve attaching screws (2) into the IAC valve.

Tighten
Tighten the idle air control valve attaching screws to 3.0 N·m (27 lb in).




4. Install the electrical connector (1) into the idle air control valve (4).
5. The powertrain control module (PCM) will reset the idle air control valve whenever the ignition switch is turned ON, then OFF.
6. Turn the ignition ON.
7. Turn the ignition OFF.
8. Perform the IAC valve learn procedure.

IAC Valve Learn Procedure

8.1.	Start and idle the engine for 15 seconds.

8.2.	Turn the ignition to the LOCK/OFF position.

8.3.	Wait 15 seconds.

8.4.	Restart the engine , and check for proper idle operation.