- Remove the key from the
ignition switch.
- Connect the passenger yellow 2-way connector (1) located
above the passenger sound insulator (3).
- Install the Connector Position Assurance (CPA) (2)
to the passenger yellow 2-way connector (1) located above the passenger
sound insulator.
- Connect the driver yellow 2-way connector located at the
base of the steering column.
- Install the Connector Position Assurance (CPA) (2) to the
driver yellow 2-way connector (1) located at the base of the steering
column.
- Install the driver sound
insulator. Refer to
Instrument Panel Insulator Panel Replacement - Left Side
in Instrument Panel, Gauges and Console.
- Install the passenger sound insulator. Refer to
Instrument Panel Insulator Panel Replacement - Right Side
in Instrument Panel, Gauges and Console.
- Connect the side air bag/pretensioner
yellow 6-way connector (2) located under the driver seat (1).
- Install the Connector Position Assurance (CPA) to the side air
bag/pretensioner yellow 6-way connector located under the driver seat
(1).
- Connect the side air bag/pretensioner yellow 6-way connector
located under the passenger front seat (1).
- Install the Connector Position Assurance (CPA) to the side air
bag/pretensioner yellow 6-way connector located under the passenger
front seat (1).
- Install the SIR fuse to the rear junction block.
- Staying well away from all air bags and the pretensioners, turn
the ignition switch to the ON position.
| 13.1. | The AIR BAG warning lamp will flash 7 times. |
| 13.2. | The AIR BAG warning lamp will then turn OFF. |
- Perform the SIR Diagnostic System Check if the AIR BAG warning
lamp does not operate as described. Refer to
SIR Diagnostic System Check
.
