GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 1999 🢒 Seville 🢒 Body and Accessories 🢒 Body Rear End 🢒 Rear Bumper Fascia Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

    2. Object Number: 105170 Size: SH
  2. Remove the push-in retainers (2) retaining the rear bumper fascia (1) to the body (1).
  3. Remove the rear wheelhouse extensions. Refer to Wheelhouse Extension Replacement - Rear in Exterior Trim.

    4. Object Number: 105167 Size: SH
  4. Remove the bolt retaining the rear bumper fascia at the wheelhouse opening.
  5. Lower the vehicle.
  6. Open the rear compartment lid.
  7. Remove the rear compartment sill plate. Refer to Rear Compartment Sill Trim Plate Replacement in Body Rear End.
  8. Remove the rear compartment side trim panels. Refer to Rear Compartment Side Trim Replacement - Left Side and Rear Compartment Side Trim Replacement - Right Side in Body Rear End.
  9. Remove the bolts retaining the rear bumper fascia to the quarter panels.

    10. Object Number: 105165 Size: SH
  10. Remove the nuts (2) retaining the rear bumper fascia (1) to the body.
  11. Remove the rear bumper fascia (1) from the body.

Installation Procedure

    Object Number: 105165 Size: SH
  1. Install the rear bumper fascia (1) to the body.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the nuts (2) to retain the rear bumper fascia (1) to the body.

    3. Tighten
    Tighten the nuts to 9 N·m (80 lb in).


    Object Number: 105167 Size: SH
  3. Install the bolts to retain the rear bumper fascia to the quarter panels.

    4. Tighten
    Tighten the bolts to 9 N·m (80 lb in).

  4. Install the rear compartment side trim panels. Refer to Rear Compartment Side Trim Replacement - Left Side and Rear Compartment Side Trim Replacement - Right Side in Body Rear End.
  5. Install the rear compartment sill plate. Refer to Rear Compartment Sill Trim Plate Replacement in Body Rear End.
  6. Close the rear compartment lid.
  7. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  8. Install the bolt retaining the rear bumper fascia at the wheelhouse opening.

    9. Tighten
    Tighten the bolts to 9 N·m (80 lb in).


    Object Number: 105170 Size: SH
  9. Install the rear wheelhouse extensions. Refer to Wheelhouse Extension Replacement - Rear in Exterior Trim.
  10. Install the push-in retainers (2) retaining the rear bumper fascia (1) to the body (1).
  11. Lower the vehicle.