Was the entire Heated Seats System Check performed?

--

Go to Step 2

Go to Heated Seats System Check

1. Disconnect the heated seat switch connector.
2. Connect a fused jumper from battery positive voltage (B+) to the heated seat switch cavity B.
3. Connect a fused jumper from ground to the heated seat switch cavity D.

Does the high heat LED light?

--

Go to Step 3

Go to Step 7

1. Disconnect the front heated seat module connector C1 or the rear door module connector C1.
2. Perform the appropriate procedure:

•	Front: Connect a DMM from the front heated seat module connector C1 cavity F (WHT) to the front heated seat switch connector cavity B (DK GRN) (LH) or (YEL) (RH).

•	Rear: Connect a DMM from the rear door module connector C1 cavity 13 (BLK/WHT) to the rear heated seat switch connector cavity A (BLK/WHT).

Is the resistance less than the specified value?

5 ohms

Go to Step 4

Go to Step 8

Is the inoperative LED for the front seat?

--

Go to Step 5

Go to Step 6

Replace the front heated seat module. Refer to Heater Module Replacement .

Is the front heated seat module replacement complete?

--

Go to Heated Seats System Check

--

Replace the rear door module. Refer to Door Control Module Replacement in Doors.

Is the rear door module replacement complete?

--

Go to Heated Seats System Check

--

Replace the heated seat switch. Refer to Front Seat Heater Switch Replacement or Door Trim Panel Replacement in Doors.

Is the heated seat switch replacement complete?

--

Go to Heated Seats System Check

--

Repair the suspect wiring:

Refer to Wiring Repairs in Wiring Systems.

Is the circuit repair complete?

--

Go to Heated Seats System Check

--