Accelerator Control Cable Replacement Domestic

1. Disconnect the accelerator control cable (2) from the accelerator controls bracket (3).



2. Disconnect the accelerator control cable (3) from the throttle body lever (2).



3. Disconnect the accelerator control cable (2) at the retainer (1) on the dash panel (bulkhead).



4. Squeeze the accelerator control cable (1) cover tangs and push the accelerator control cable through dash panel (bulkhead).
5. Remove the left instrument panel sound insulator. Refer to Instrument Panel, Gages And Console.



6. Disconnect the accelerator control cable (1) at the accelerator controls pedal (3).
7. Remove the accelerator control cable.

Notice: In order to prevent possible interference and damage, flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2 in) of moving parts, unless the routing is positively controlled.

1. Install the accelerator control cable (3) at the throttle body lever (2).
2. Install the accelerator control cable (3) at the accelerator controls cable bracket (1).

Important: Accelerator control cable must be routed through groove in throttle body lever and seated securely.




3. Route the accelerator control cable (2) over the brake master cylinder and through the dash.
4. Secure the accelerator control cable (2) at the retainer (1) on the dash (bulkhead).



5. Install the accelerator control cable (1) at accelerator controls pedal (3).

Important: Check for complete throttle opening and closing positions by operating accelerator controls pedal. Also check for poor carpet fit under the accelerator controls pedal. Throttle should operate freely without bind between full closed and wide open throttle.

6. Reinstall the left instrument panel sound insulator. Refer to Instrument Panel, Gages And Console.

Accelerator Control Cable Replacement Export

1. Remove the accelerator controls cable (3) from the throttle body bracket (1).
2. Remove the accelerator controls cable (3) from the throttle body lever (2).



3. Remove the accelerator controls cable (2) from the bulkhead retainer (1).



4. Remove the accelerator controls cable (1) from the engine compartment.



5. Remove the right Closeout/Insulator Panel Replacement - IP Lower. Refer to Instrument Panel Insulator Panel Replacement - Right Side .
6. Remove the accelerator controls cable (1) from the accelerator controls pedal (3).
7. Remove the accelerator controls cable to bulkhead seal.
8. Remove the accelerator controls cable (1) from the bulkhead and from the vehicle.

Notice: In order to prevent possible interference and damage, flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2 in) of moving parts, unless the routing is positively controlled.

1. Install the accelerator controls cable (1) to the vehicle and to the bulkhead.
2. Install the accelerator controls cable to bulkhead seal.
3. Install the accelerator controls cable (1) to the accelerator controls pedal assembly (3).
4. Install the right closeout/insulator panel replacement - IP lower. Refer to Instrument Panel Insulator Panel Replacement - Right Side .



5. Route the accelerator controls cable (2) through the engine compartment.
6. Install the accelerator controls cable (2) to the bulkhead retainer (1).




Important: The accelerator controls cable must be routed through groove in throttle body lever and seated securely.

7. Install the accelerator controls cable (3) to the throttle body lever (2).
8. Install the accelerator controls cable (3) to the throttle body bracket (1).

Important: Inspect for complete throttle opening and closing positions by operating the accelerator controls pedal. Inspect for poor carpet fit under the accelerator controls pedal. Throttle should operate freely without binding between full closed and wide open throttle.

9. Inspect the accelerator control cable for proper operation.