The column is not aligned correctly.

1. Check the following:

•	Check the column alignment.

•	Check the mounting.

•	Check the bearings.

2. Adjust repair and/or replace as needed.

Refer to Steering Column Replacement .

The shaft seal is deformed or improperly installed.

1. Inspect for proper installation.
2. Reseat and tighten to specifications. Refer to Fastener Tightening Specifications .

The intermediate shaft universal joint is tight.

Clean, inspect and replace as needed.

Refer to Intermediate Steering Shaft Seal Replacement .

The upper or the lower bearing is damaged.

1. Inspect the upper and/or the lower bearing(s).
2. Replace as needed.

Refer to Steering Shaft, Lower Bearing, and Jacket - Disassemble - Off Vehicle .