Removal Procedure
- Disable the SIR. Refer to Disabling the SIR System in SIR.
- Remove the instrument panel upper trim panel. Refer to Instrument Panel Upper Trim Pad Replacement .
- Remove the fasteners (2) securing defroster grille to instrument panel carrier.
- Remove the defroster grille (3).
- Disconnect the sensors from the defroster grille. Refer to Sunload and Twilight Sentinel Sensor Replacement .
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• Air bag deployment • Personal injury • Unnecessary SIR system repairs • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.
Installation Procedure
- Connect the sensors to the defroster grille. Refer to Sunload and Twilight Sentinel Sensor Replacement .
- Align the defroster grille (3) with IP carrier.
- Install the fasteners (2) from defroster grille to carrier.
- Install the instrument panel upper trim panel. Refer to Instrument Panel Upper Trim Pad Replacement .
- Enable the SIR. Refer to Enabling the SIR System in SIR.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the defroster grille fasteners to 2 N·m (18 lb in).
