GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 1999 🢒 Seville 🢒 Engine 🢒 Engine Electrical 🢒 Instrument Cluster Trim Panel Replacement

Removal Procedure

    Object Number: 105548 Size: SH
  1. Remove the instrument panel (IP) upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement .
  2. Remove the two fasteners, one on each side of the cluster.
  3. Disconnect the left (1) and right (2) drivers information center (DIC) switch electrical connectors.
  4. Rotate the IP cluster trim (3) rearward from the top and lift out of IP retainer.
  5. Remove the left and right drivers information center switches. Refer to Driver Information Display Switch Replacement .

Installation Procedure
  1. Install the DIC switches to the IP cluster trim panel. Refer to Driver Information Display Switch Replacement .

    2. Object Number: 105548 Size: SH
  2. Slide the lower edge of IP cluster trim plate down behind woodgrain trim.
  3. Reconnect the two electrical connectors (1, 2) to DIC switches.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the two fasteners from the trim panel to IP retainer.

    5. Tighten
    Tighten the IP cluster trim panel fasteners to 2 N·m (18 lb in).

  5. Install the IP upper trim pad. Refer to Instrument Panel Upper Trim Pad Replacement .