Control Assembly Replacement with UL6, UL7, UM5, UM9, and U1R

1. Remove the instrument panel center trim plate. Refer to Instrument Panel Center Trim Panel Replacement in instrument Panel, Gauges and Console.
2. Remove the console trim plate. Refer to Console Trim Plate Replacement in instrument Panel, Gauges and Console.
3. Remove the control assembly bracket fasteners.
4. Disconnect the electrical connectors from the control assembly and radio.



5. Remove the control assembly and radio.



6. Remove the control assembly retaining nuts.
7. Remove the control assembly from the bracket.

1. Install the control assembly to the bracket.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the control assembly retaining nuts

Tighten
Tighten the retaining nuts to 10 N·m (88 lb in).




3. Connect the electrical connectors to the control assembly and radio.
4. Install the control assembly and radio to vehicle.



5. Install the control assembly bracket fasteners.
6. Install the console trim plate. Refer to Console Trim Plate Replacement in instrument Panel, Gauges and Console.
7. Install the instrument panel center trim panel. Refer to Instrument Panel Center Trim Panel Replacement in instrument Panel, Gauges and Console.
8. Recalibrate the control assembly. Refer to Body Control Module (BCM) Programming/RPO Configuration in Body Control System.

Control Assembly Replacement with UY4

1. Remove the instrument panel center trim plate. Refer to Instrument Panel Center Trim Panel Replacement in Instrument Panel, Gauges and Console.
2. Remove the console trim plate. Refer to Console Trim Plate Replacement in Instrument Panel, Gauges and Console.
3. Remove the control assembly bracket fasteners.
4. Disconnect the electrical connector from the control assembly.



5. Remove the control assembly.



6. Remove the control assembly retaining nuts.
7. Remove the control assembly from the bracket.

1. Install the control assembly to the bracket.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the control assembly retaining nuts

Tighten
Tighten the radio retaining nuts to 10 N·m (88 lb in).




3. Install the control assembly to vehicle.



4. Connect the electrical connector to the control assembly.
5. Install the control assembly bracket fasteners.
6. Install the console trim plate. Refer to Console Trim Plate Replacement in Instrument Panel, Gauges and Console.
7. Install the instrument panel center trim plate. Refer to Instrument Panel Center Trim Panel Replacement in Instrument Panel, Gauges and Console.
8. Recalibrate the control assembly. Refer to Body Control Module (BCM) Programming/RPO Configuration in Body Control System.