Sunroof Does Not Open to the Vent Position
Step
| Action
| Value(s)
| Yes
| No
|
1
| Was Power Sunroof System Check
performed?
| --
| Go to Step 2
| Go to
Power Sunroof System Check
|
2
|
- Turn the ignition to OFF.
- Disconnect the harness connector C1 from the Overhead Console
Sunroof Switch.
- Turn the ignition to RUN.
- Using a fused jumper wire, jumper terminal 1 to terminal 2 of
the Overhead Console Sunroof Switch harness connector C1.
Did the sunroof vent open?
| --
| Go to Step 5
| Go to Step 3
|
3
|
- Turn the ignition to OFF.
- Disconnect the Sunroof Control Module harness connector C2 from
the module.
- Measure the resistance from terminal 1 of the Overhead Console
Sunroof Switch harness connector C1, to terminal 7 of the Sunroof Control
Module harness connector C2.
Is the resistance within range specified?
| 0-3 ohms
| Go to Step 4
| Go to Step 6
|
4
| Replace the
Sunroof Control Module.
Is the repair complete?
| --
| Go to
Power Sunroof System Check
| --
|
5
| Replace the Power Sunroof Vent Switch.
Is the repair complete?
| --
| Go to
Power Sunroof System Check
| --
|
6
| Repair open in CKT 144 between the Sunroof Control Module and the Overhead
Console Sunroof Switch.
Is the repair complete?
| --
| Go to
Power Sunroof System Check
| --
|
