Caution: Striker alignment is crucial for proper operation of the door systems. Do not hit the striker with a hammer or force alignment in any other way. Failure to properly adjust striker will result in excessive door efforts or extensive damage to door system operation which could result in personal injury.

Tools Required

J 39346-A Mini-Wedge Alignment Tool

1. Loosen the two mini wedge striker bolts (1).
2. Tighten the two striker bolts so that the striker can still be moved.



3. Place the J 39346-A over the striker (2).
4. Hold the outside door handle out and gently push the door flush against the body to locate the striker.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Slowly open the door.

Tighten
Tighten the striker bolts to 27 N·m (20 lb ft).

6. Remove the J 39346-A .
7. After the striker adjustment touch up any exposed or unpainted surface.