Was the entire Navigation System Check performed?

--

Go to step 2

Go to Navigation System Check

Verify that the video component connected to the vehicle is operating properly.

Is the video component operating properly?

--

Go to step 3

System OK

1. Disconnect the Aux RCA Video Jacks connector.
2. Measure the voltage between cavity D of the Aux RCA Video Jacks harness connector and ground with a DMM.

Is the voltage measured within the specified range?

0 V

Go to step 4

Go to step 5

1. Disconnect the Navigation Display Module connector C3.
2. Measure the resistance between cavity D of the Aux RCA Video Jacks harness connector and cavity 11 of the Navigation Display Module harness connector C3 with a DMM.

Is the resistance measured within the specified range?

0-2 ohms

Go to step 6

Go to step 7

Repair the short to B+ in circuit 2060 between cavity D of the Aux RCA Video Jacks connector and cavity 11 of the Navigation Display Module connector C3. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Navigation System Check

--

Replace the Aux RCA Video Jacks. Refer to Auxiliary Audio/Video Input Control Replacement in Instrument Panel, Gauges and Console.

Is the replacement complete?

--

Go to Navigation System Check

--

Repair the open in circuit 2060 between cavity D of the Aux RCA Video Jacks connector and cavity 11 of the Navigation Display Module connector C3. Refer to Wiring Repairs in Wiring Systems.

Is the repair complete?

--

Go to Navigation System Check

--