Removal Procedure
Caution: Provide additional support when a vehicle is on a hoist:
• Before removing parts, support the opposite end. This helps prevent
the vehicle from slipping off. • Before removing major components, chain the vehicle frame to the
hoist pads at the same end as the removal. This helps avoid a tip-off.
- Raise the vehicle.
- Mark the hoses for installation on to the canister.
- Remove the EVAP vent hose (1).
- Remove the fuel tank vapor hose (2).
- Remove the purge hose (3).
- Remove the nuts (2) from the canister.
- Remove the canister (1) from the bracket by releasing tabs.
Installation Procedure
- Install the EVAP canister on the bracket.
- Reinstall the EVAP canister to the underbody with the 3 nuts.
- Connect the purge hose (3) to the canister.
- Connect the fuel tank vapor hose (2) canister.
- Connect the vent hose (1) to the canister.
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the EVAP canister nuts to 9 N·m (80 lb in).
