For 1990-2009 cars only
Removal Procedure
- Apply 2 layers of masking tape on the windshield next to the reveal molding (3) being serviced.
- Remove the screws (2) from the reveal molding.
- If the molding is bent or damaged, replace the molding.
Installation Procedure
- If the windshield reveal molding (3) retainer clips are bent or damaged, replace the clips.
- Align the top end of the reveal molding to the end cap tongue inside the opening of the roof rail.
- Install the reveal molding downward and align the reveal molding with the screw holes.
- Install the reveal molding screws (2) and tighten to 2 N·m (18 lb in).
- Remove the masking tape.
- Clean the tape residue from the windshield.
Caution: Refer to Fastener Caution in the Preface section.
