Heater Inlet Hose/Pipe and Heater Outlet Hose/Pipe Replacement Right Hand Drive

Tools Required

J 38185 Hose Clamp Pliers

1. Partially drain the cooling system. Refer to Cooling System Draining and Filling .



2. Position J 38185 to the clamp in order to remove the heater inlet/outlet hose (1) from the engine side of heater pipes (2).



3. Position J 38185 to the clamp in order to remove the heater inlet/outlet hose (2) from the heater core pipes.
4. Remove brace from inside of strut tower (1).



5. Remove the heater inlet/outlet hose/pipe nuts (1) from the attaching studs and remove the heater inlet/outlet hose/pipe from vehicle.

Notice: Refer to Fastener Notice in the Preface section.




1. Position the heater inlet/outlet hose/pipes (2) and install the heater inlet/outlet hose/pipe nuts (1) to the attaching studs.

Tighten
Tighten the nuts to 6 N·m (53 lb in).




2. Position J 38185 to the clamp (2) in order to connect the inlet/outlet hose/pipe to the heater core.
3. Install brace to strut tower to secure heater inlet/outlet hose/pipes (1).



4. Position J 38185 to the clamp (1) in order to connect the inlet/outlet hose/pipe to the engine side of pipes (2).
5. Fill the cooling system. Refer to Cooling System Draining and Filling .