Important: Always perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
The liftgate ajar indicator uses the ajar switch located in the liftgate latch to determine if the liftgate is open. With the liftgate open, the liftgate ajar switch is closed. This grounds the liftgate ajar switch signal circuit, indicating to the rear integration module (RIM) that the liftgate is ajar. The RIM will then send a serial data message to the driver information center (DIC) requesting the LIFT GATE AJAR message be illuminated.
A malfunctioning liftgate latch, in which the ajar switch is stuck in the closed position, will cause the LIFT GATE AJAR message to be displayed at all times.
Body Rear End Connector End Views
With the liftgate closed, view the DIC. The liftgate ajar message should not be displayed.
⇒ | If the parameter is ACTIVE with the liftgate closed, test the liftgate ajar switch signal circuit for a short to ground. If all circuits test normal, test or replace the liftgate latch. |
⇒ | If less than infinite resistance, replace the liftgate latch. |
⇒ | If greater than 1 ohm, replace the liftgate latch. |
⇒ | If greater than infinite resistance, replace the liftgate latch. |
Important: Always perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• | Control Module References for RIM replacement, setup, and programming |