Circuit Description
The electronic brake control module (EBCM) receives a signal from the brake pedal position sensor through the brake position sensor signal circuit. The EBCM then applies a signal through the TCC/brake/cruise control release switch signal circuit to the transmission control module (TCM) and engine control module (ECM).
Conditions for Running the DTC
| • | The vehicle has cycled from 0-60 km/h (0-37 mph) 3 times in 1 ignition cycle. |
| • | Continuous once the previous criteria have been met. |
Conditions for Setting the DTC
The TCM detects voltage on the TCC/brake/cruise control release switch signal circuit when the circuit should be open.
Action Taken When the DTC Sets
| • | The TCM stores the DTC information into memory when the diagnostic runs and fails. |
| • | The malfunction indicator lamp (MIL) will not illuminate. |
| • | The TCM records the operating conditions at the time the diagnostic fails. The TCM stores this information in the failure records. |
Conditions for Clearing the DTC
| • | A last test failed, or current DTC, clears when the diagnostic runs and does not fail. |
| • | A history DTC will clear after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic. |
| • | Use a scan tool in order to clear the DTC. |
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Master Electrical Component List in Wiring Systems | |||
1 | Did you perform the Lighting System Diagnostic System Check? | Go to Step 2 | |
2 | Test for a short to battery positive voltage in the TCC/brake/cruise control release switch signal circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 5 | Go to Step 3 |
3 | Inspect for poor connections at the harness connector of the transmission control module (TCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems. Did you find and correct the condition? | Go to Step 5 | Go to Step 4 |
4 | Replace the TCM. Refer to Transmission Control Module Replacement in Automatic Transmission - 5L40-E or Transmission Control Module Replacement in Automatic Transmission - 5L50-E. Did you complete the repair? | Go to Step 5 | -- |
5 |
Does the DTC reset? | Go to Step 2 | System OK |
