Removal Procedure
Notice: DO NOT apply paint or clear coat to
the antenna. This will damage the function of the antenna, causing poor reception
or loss of signal reception.
Notice: Use care when removing and installing the headliner. If reusing the headliner lay the headliner down flat on a clean surface. Excessive bending will
damage the headliner.
- Lower the headliner in order to access
the antenna. Refer to
Headlining Trim Panel Replacement in Interior Trim.
- Disconnect the cables (4) from the antenna
base (1).
- Remove the bolt (3) and expansion sleeve (2).
- Remove the antenna base (1) from the roof.
Installation Procedure
- Place the antenna base to the roof opening.
Notice: Refer to Fastener Notice in the Preface section.
- Install the expansion sleeve (2) and the bolt (3).
Tighten
Tighten the nut to 6 N·m (53 lb in).
- Connect the antenna cables (4).
- Install the headliner. Refer to
Headlining Trim Panel Replacement in Interior
Trim.