Circuit Description
This DTC is generated by the module when an error occurs between the VIN as received over the class 2 communication circuit and the VIN as stored in the module memory. The only circuit required is the class 2 communications line.
Conditions for Running the DTC
The DTC is run when the Radio changes from OFF to ON. This may be in response to the radio switch or the ignition ON signal.
Conditions for Setting the DTC
This DTC is generated by the module when an error occurs between the VIN as received over the class 2 communication circuit and the VIN as stored in the module memory. This happens when the radio changes from OFF to ON.
Action Taken When the DTC Sets
The radio does not function. The radio also displays as many characters of the word "CALIBRATE" as will fit in the radio display.
Conditions for Clearing the MIL/DTC
Re-calibration with the correct calibrations for the vehicle and cycling the radio to OFF then to ON will clear the DTC if there is no damage to the radio.
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Radio/Audio System Schematics Connector End View Reference: Entertainment Connector End Views | |||
1 | Did you perform the Entertainment System Diagnostic System Check? | Go to Step 2 | |
2 |
Does the DTC reset? | Go to Step 3 | System OK |
3 |
Important:: Perform the set up procedure for the radio. Replace the radio. Refer to Radio Replacement . Did you complete the replacement? | System OK | -- |
