GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Cadillac
🢒
2009
🢒
SLS
🢒
Power and Signal Distribution
🢒
Wiring Systems and Power Management
🢒 Camshaft Position Actuator Solenoid Valve Solenoid Replacement - Bank 1 (Right Side) Exhaust
Removal Procedure
Turn the ignition OFF.
Remove the front compartment sight shield, if necessary. Refer to
Front Compartment Sight Shields Replacement
.
Remove the ECM and the ECM bracket. Refer to
Engine Control Module Replacement
.
Disconnect the camshaft position (CMP) actuator valve electrical connector.
Remove the CMP actuator valve bolts.
Remove the CMP actuator valve.
Inspect the CMP actuator valve seal for damage. Replace components if necessary.
Installation Procedure
Inspect the CMP actuator valve seal for damage. Replace components if necessary.
Install the CMP actuator valve.
Caution:
Refer to
Fastener Caution
in the Preface section.
Install the CMP actuator valve bolt and tighten to
10 N·m (89 lb in)
.
Connect the CMP valve electrical connector.
Install the ECM and the ECM bracket. Refer to
Engine Control Module Replacement
.
Install the front compartment sight shields as necessary. Refer to
Front Compartment Sight Shields Replacement