Circuit Description
The memory seat module (MSM) receives an input from the left seat switch recline switch when the switch is actuated. When the recline switch is operated in the forward direction, the MSM recline forward input via CKT 1269 (GRY/BLK) is grounded. The MSM recognizes the input and moves the seat back in the forward direction.
Conditions for Setting the DTC
| • | When the recline forward switch is active for 30 seconds after motion has ceased, the switch is considered shorted and the DTC sets. |
| • | If the seat recline position sensor DTC B2115 is current and the recline forward switch is active for 30 seconds, the switch is considered shorted and the DTC sets. |
| • | DTC B2102 sets only if DTC B1982 MSM or DTC B1983 MSM is not current. |
Action Taken When the DTC Sets
| • | The MSM does not recline the seat back in the forward direction. |
| • | The MSM continues responding to valid inputs from the other manual switches. |
| • | All memory recall function commands are ignored for all directions. |
Conditions for Clearing the DTC
| • | The MSM sees that the recline forward switch is no longer active. |
| • | Use the on-boards clearing DTCs feature. |
| • | Use a scan tool. |
Test Description
The numbers below refer to the step numbers on the diagnostic table:
-
Perform the Power Seat Systems Diagnostic System Check before continuing with the diagnosis of this DTC.
-
This step determines if a switch is stuck or if a short to ground exists in the wiring input to the memory seat module (MSM). DTC B2102 will set again if a short in the wiring exists or if an internal MSM condition exists. DTC B2102 will not set again if a switch is stuck because the switch has been disconnected from the memory seat module (MSM) input.
-
This step determines if a short to ground exists in the input wiring to the MSM.
-
Clear all DTCs after the repair procedure is complete.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Was the entire Power Seat Systems Diagnostic System Check performed? | -- | Go to Step 2 | ||
After 30 seconds, does DTC B2102 reset? | -- | Go to Step 3 | Go to Step 5 | |
Is the resistance less than the specified value? | 5 ohms | Go to Step 6 | Go to Step 4 | |
4 | Replace the memory seat module (MSM). Refer to Memory Seat Control Module Replacement . Is the MSM replacement complete? | -- | Go to Step 7 | -- |
5 | Replace the LH seat switch. Refer to Power Seat Switch Replacement . Is the LH seat switch replacement complete? | -- | Go to Step 7 | -- |
6 | Repair the short to ground in CKT 1269 (GRY/BLK). Refer to Wiring Repairs in Wiring Systems. Is the circuit repair complete? | -- | Go to Step 7 | -- |
Is the action complete? | -- | -- |
