Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Wiper/Washer System Check or Wiper/Washer System Check

1. Disconnect wiper motor harness connector C1.
2. Turn the ignition switch ON.
3. Set the wiper switch to LO.
4. Connect a J 35616-200 from wiper motor connector C1, terminal F (w/o CE1) or terminal G (w/CE1), to ground.
5. Momentarily activate the washer switch while observing the J 35616-200 .

Is the test light on after the washer switch is released?

--

Go to Step 3

Go to Step 4

Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle in Steering Wheel and Column - Tilt.

Is the replacement complete?

--

Go to Wiper/Washer System Check or Wiper/Washer System Check

--

Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement .

Is the replacement complete?

--

Go to Wiper/Washer System Check or Wiper/Washer System Check

--