Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Did you perform the Lighting Systems Diagnostic System Check? | -- | Go to Step 2 | |
2 | Place the headlamp switch in the HEAD position. Measure voltage from RH high beam headlamp connector terminal A to ground. Is battery voltage measured? | -- | Go to Step 3 | Go to Step 5 |
3 | Inspect CKT 359 for an open from RH high beam headlamp connector terminal B to connector C103 terminal G. Refer to Testing for Continuity in Wiring Systems. Is CKT 359 OK? | -- | Go to Step 4 | Go to Step 6 |
4 | Repair open in CKT 750 from connector C103 terminal G to S107. Is the repair complete? | -- | Go to Step 7 | -- |
5 | Repair open in CKT 311 between RH high beam headlamp connector terminal A to the underhood fuse block. Is the repair complete? | -- | Go to Step 7 | -- |
6 | Repair open in CKT 359. Is the repair complete? | -- | Go to Step 7 | -- |
7 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK. | Go to Step 2 |
