Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

Caution: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.

1. Disable the SIR system. Refer to Disabling the SIR System .
2. Mark the location of the hinge.
3. Remove the bolts from the body.
4. Remove the hinge (1,3) from the body (4).

1. Install the hinge (1,3) to the body (4).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the bolts.

Tighten
Tighten the bolts to 48 N·m (35 lb ft).

3. Install the door (2) to the hinges (1,3). Door Replacement

Tighten
Tighten the bolts to 48 N·m (35 lb ft).

4. Inspect the door (2) for the proper alignment.
5. Adjust the door as needed. Refer to Door Adjustment .
6. Enable the SIR system. Refer to Enabling the SIR System .