GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Cadillac 🢒 1999 🢒 Eldorado 🢒 Body and Accessories 🢒 Body Front End 🢒 Front End Sheet Metal Support Replacement

Removal Procedure
  1. Remove the hood primary latch. Refer to Hood Primary Latch Replacement .
  2. Remove the electrical connector and the ambient temperature sensor. Refer to Ambient Temperature Sensor Replacement in HVAC.
  3. Loosen the power steering cooler pipe bolt at the center support. Refer to Power Steering Pump Replacement in Power Steering Gear and Pump.

    4. Object Number: 366313 Size: SH
  4. Remove the nuts (3) and the bolts (1) that retain the center support (2).
  5. Remove the center support (2).

Installation Procedure

    Object Number: 366313 Size: SH
  1. Install the center support (2).

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the nuts (3) and the bolts (1).

    3. Tighten
    Tighten the nuts and the bolts to 12 N·m (106 lb in).

  3. Install the bolt that retains the power steering cooler to the center support.
  4. Install the following components. Refer to Ambient Temperature Sensor Replacement in HVAC:
    5. • The ambient air temperature sensor
    • The screw
    • The electrical connector.
  5. Install the hood primary latch. Refer to Hood Primary Latch Replacement .

    6. Adjust the latch as needed.