For 1990-2009 cars only
Removal Procedure
- Carefully pry away the molding (1,4) from the body.
- Remove the old adhesive from the panel and the molding if you are reusing the molding.
Important:
• Ensure that you protect the surrounding surfaces. • Use care not to damage the paint.
Insert a thin bladed tool between the molding and the sheet metal.
Important: Do not use rotating adhesive removal discs on the moldings. This generates excessive heat, which may damage the moldings.
Use 3M General Purpose Adhesive Cleaner 08984 or an equivalent. You may also use 3M Scotch-Brite Adhesive Removal Discs on the body panels.
Installation Procedure
- If you are reusing the molding, apply new adhesive tape (4) to the molding and remove the backing.
- Align the molding (1,5).
- Align and press the molding to the body:
If needed, mark the reference on the body with masking tape in order to aid in alignment once the adhesive liner is removed.
| • | Wear clean gloves or use a clean towel while you perform this step. |
| • | Apply heavy hand pressure against the molding at the tape locations in order to assure proper adhesive wetout. |
| • | Rub along the entire length of the molding. |
