Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Wiper/Washer System Check

1. Disconnect the wiper motor connector C1.
2. Turn the ignition switch ON.
3. Set the wiper switch to OFF.
4. Measure the voltage from connector C1, terminal B to ground with a J 39200.

Is the measurement within the specified values?

10.5-15 V

Go to Step 3

Go to Step 5

Inspect for a short to voltage in CKT 91.

Was a short to voltage found?

--

Go to Step 6

Go to Step 4

Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle .

Is the replacement complete?

--

Go to Wiper/Washer System Check

--

1. Disconnect the wiper motor connector C2.
2. Measure the voltage from connector C2, terminal A, to ground with a J 39200.

Is the measurement within the specified values?

10.5-15 V

Go to Step 7

Go to Step 8

Repair the short to voltage in CKT 91.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Repair the short to voltage in CKT 92.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Repair the short to voltage in CKT 196.

Is the repair complete?

--

Go to Wiper/Washer System Check

--