Automatic Transmission Shift Lock Control Assemble - Off Vehicle. Cadillac Eldorado 1999

Assembly Procedure

Tools Required

J 41352 Modular Column Holding Fixture

•	The column must be in the 12 o'clock position.

Important: To align the steering shaft assembly to the 12 o'clock position. Turn the key to the off/lock position. Pull the key out and turn the steering shaft untill you hear a click.

•	Install the solenoid bracket (2) onto the steering column jacket (3).

•

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Install the 2 washer head screws (1).

Tighten
Tighten the screws to 4 N·m (35 lb in).

•	Install the interlock solenoid assembly (7).

•	Install the ball joint spring (5).

•	Install the hex washer head screw (6). Tighten Tighten the screw to 4 N·m (35 lb in).

•	Reconnect the ignition switch actuator assembly (4).

•	Put the wire harness assembly into the wire harness strap (1).

•	Turn the key to the on position to unlock the steering shaft.

•	Remove the column from the J 41352 .