Disassembly Procedure
- Remove the lock housing cover and sleeve assembly. Refer to
Steering Column Jacket - Disassemble - Off Vehicle
.
- Remove the switch actuator
pivot pin (2) from the pivot and pulse switch assembly (1).
- If removal of the pivot and pulse switch assembly (1) is
not needed let the pivot and pulse switch assembly (1) hang freely.
- Remove the pivot and pulse switch assembly (1) from the
lock housing cover and sleeve assembly following these steps:
4.1. | Remove the wire protector shield. |
4.2. | Remove the pivot and pulse switch assembly connector from the
bulk head connector. |
| Important: Use care not to damage the wires when pulling the pivot and pulse switch
assembly wire harness through the steering column.
|
4.3. | Pull the wire harness through the steering column. |