For 1990-2009 cars only
Removal Procedure
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle General Information.
- Remove the wheel from the vehicle. Refer to Tire and Wheel Removal and Installation Tires and Wheels.
- Disconnect the sensor harness connector from the vehicle harness connector.
- Disconnect three sensor harness clips from the vehicle.
- Disconnect the sensor link from the ball stud.
- Remove the two screws and the position sensor from the vehicle.
Installation Procedure
- Install the position sensor on the vehicle with two screws.
- Connect the sensor link to the ball stud.
- Connect the three sensor harness clips onto the vehicle.
- Connect the sensor harness connector to the vehicle harness connector.
- Install the wheel onto the vehicle. Refer to Tire and Wheel Removal and Installation Tires and Wheels.
- Lower the vehicle. Refer to Lifting and Jacking the Vehicle General Information.
- Perform the ALC Trim Height Adjustment. Refer to Trim Height Adjustment .
Tighten
Tighten two screws to 15 N·m (11 lb ft).
