GM Service Manual Online
For 1990-2009 cars only

Step

Action

Value(s)

Yes

No

1

Were you sent here from a DTC diagnostic chart?

--

Go to Step 7

Go to Step 2

2

Display and record all CVRSS DTCs and the status of each (CURRENT vs. HISTORY) using the On-Board Diagnostics via the Instrument Panel Cluster. Refer to Displaying Diagnostic Trouble Codes (DTC) .

Does the IPC display NO RSS DATA?

--

Go to No RSS Data Loss of Serial Communications or Power

Go to Step 3

3

Are there any CVRSS CURRENT DTCs (i.e. CXXXX CURRENT, where XXXX is a four digit number)?

--

Go to Diagnostic Trouble Code (DTC) List/Type

Go to Step 4

4

  1. Clear the CVRSS DTCs. Refer to Clearing DTCs .
  2. Important: Do not turn the ignition off after performing the road test.

    Road test the vehicle (drive the vehicle above 50 MPH for 10 seconds and avoid smooth road surfaces).

  3. After completing the road test, use the scan tool to cycle ALL CVRSS outputs.
  4. Wait 90 seconds.
  5. Display and record all CVRSS DTCs and the status of each (CURRENT vs. HISTORY) using the On-Board Diagnostics via the Instrument Panel Cluster. Refer to Displaying Diagnostic Trouble Codes (DTC) .

Are there any CVRSS CURRENT DTCs?

--

Go to Diagnostic Trouble Code (DTC) List/Type

Go to Step 5

5

Were there any CVRSS HISTORY DTCs (i.e. CXXXX HISTORY, where XXXX is a four digit number)?

--

Go to Diagnostic Trouble Code (DTC) List/Type

Go to Step 6

6

There are no apparent electrical faults. Inspect for pneumatic, hydraulic, or mechanical causes for the complaint.

Did you find a pneumatic, hydraulic, or mechanical cause for the complaint?

--

Refer to the appropriate repair procedure.

System OK

7

  1. Install all of the components and connectors that were removed.
  2. Turn the ignition ON with the engine off.
  3. Clear the CVRSS DTCs. Refer to Clearing DTCs .
  4. Road test the vehicle (drive the vehicle above 50 MPH for 10 seconds and avoid smooth road surfaces).

  5. After completing the road test, use the scan tool to cycle ALL CVRSS outputs.
  6. Wait 90 seconds.
  7. Using the On-Board Diagnostics via the Instrument Panel Cluster, display and record all CVRSS DTCs and the status of each (CURRENT vs. HISTORY). Refer to Displaying Diagnostic Trouble Codes (DTC)

Are there still other CURRENT CVRSS DTCs?

--

Go to Diagnostic Trouble Code (DTC) List/Type

System OK