- Remove the key from the
ignition switch.
- Connect the inflatable restraint IP module yellow 2-way connector
(2).
- Attach the inflatable restraint IP module yellow 2-way
connector (1) to the IP sheetmetal.
- Ensure the pigtail and harness wiring is routed away from the
HVAC mix door actuator.
- Install the Connector
Position Assurance (CPA) (2) to the inflatable restraint IP module
yellow 2-way connector (1).
- Attach the inflatable
restraint IP module yellow 2-way connector (1) to the IP sheetmetal.
- Install the IP compartment. Refer to
Instrument Panel Storage Compartment Replacement
in Instrument Panel, Gauges, and
Console.
- Connect the inflatable
restraint steering wheel yellow 2-way connector (4) located
near the base of the steering column (2).
- Install the Connector
Position Assurance (CPA) (4) to the inflatable restraint steering wheel
yellow 2-way connector (1) located near the base of the steering
column (2).
- Install the left side sound insulator. Refer to
Driver Knee Bolster Reinforcement Replacement
Instrument
Panel, Gauges, and Console.
- Enable the side air bags (1)
if disabled. Refer to the following procedures to enable the side air bags.
| 11.1. | Connect the inflatable restraint side air bag inflator module
yellow 2-way connector (2). |
| 11.2. | Install the Connector Position Assurance (CPA) (3) to the
inflatable restraint side air bag module yellow 2-way connector (2). |
| 11.3. | Install the door trim panel. Refer to Door Trim Panel in Doors. |
- Install the SIR fuse to the trunk compartment fuse block.
- Staying well away from both air bags, turn the ignition switch
to the RUN position.
| • | The AIR BAG warning lamp will flash 7 times. |
| • | The AIR BAG warning lamp will then turn OFF. |
- Perform the SIR Diagnostic System Check if the AIR BAG warning
lamp does not operate as described.
