Removal Procedure
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Position the oil drain pan under the engine oil drain plug.
- Remove the engine oil drain plug.
- Clean and inspect the engine oil drain plug, repair or replace if necessary.
- Clean and inspect the engine oil drain plug sealing surface on the oil pan, repair or replace oil pan if necessary.
- Remove the oil filter.
- Clean and inspect the oil filter sealing area on the oil filter adapter, repair or replace if necessary.
Installation Procedure
- Lightly oil the replacement oil filter gasket with clean oil and install the new oil filter.
- Install the new oil filter.
- Install the engine oil drain plug.
- Lower the vehicle.
- Fill the engine with new engine oil. Refer to Engine Mechanical Specifications .
- Inspect for oil leaks after engine start up.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the new oil filter to 3/4 to 1 full turn, after the oil filter
gasket contacts the oil filter mounting surface.
Tighten
Tighten the engine oil drain plug to 20 N·m (15 lb ft).
in Maintenance and Lubrication.
