GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Cadillac
🢒
2003
🢒
DeVille
🢒
Body and Accessories
🢒
Seats
🢒 Front Seat Recliner Position Sensor Replacement
Removal Procedure
Caution:
Refer to
SIR Caution
in the Preface section.
Remove the front bucket seat. Refer to
Bucket Seat Replacement
.
Remove the seat back trim cover. Refer to
Front Seat Back Trim Replacement
.
Remove the push pin retainer (1) from the edge of the lower seat belt retractor trim cover (2).
Release the rear of the lower seat belt retractor trim cover (2), and remove the trim cover (2).
Remove the retainer clip from the recliner motor end of the recliner shaft.
Slide the recliner shaft out of the recliner motor sensor at the outboard side far enough to clear the sensor.
Disconnect the recliner sensor electrical connector from beneath the seat .
Release the recliner sensor from the recliner motor.
Installation Procedure
Snap the recliner sensor to the recliner motor.
Slide the recliner shaft back through the recliner sensor and the recliner motor.
Install the retaining clip to the recliner shaft.
Connect the recliner motor electrical connector.
Install the seat back trim cover. Refer to
Front Seat Back Trim Replacement
.
Install the lower seat belt retractor trim cover (2).
Install the push pin fastener (1)
Install the front bucket seat. Refer to
Bucket Seat Replacement
.
Calibrate the seat. Refer to
Memory Seat Calibration
.