Removal Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• | Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
• | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
• | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the SIR system. Refer to
Disabling the SIR System
in SIR.
- Remove the steering column trim covers. Refer to
Steering Column Trim Covers Replacement - On Vehicle
.
- Disconnect the theft deterrent module
electrical connector.
- Remove the tie straps from the theft deterrent module wiring harness.
- Remove the theft deterrent module.
Installation Procedure
- Install the theft deterrent module to
the lock module.
- Connect the theft deterrent module electrical connector.
- Install new tie straps to secure the wiring harness.
- Install the steering column trim covers. Refer to
Steering Column Trim Covers Replacement - On Vehicle
.
- Enable the SIR system. Refer to
Enabling the SIR System
in
SIR.