Removal Procedure
- Remove the rear compartment front trim panel. Refer to one of
the following procedures:
- Remove the 2 nuts from the upper section of the board.
- Remove the 2 nuts (3)
from the lower section of the bay board (1).
- Lay the bay board (1) into the rear compartment.
- Remove any modules, if necessary.
Installation Procedure
- Install the bay board (1)
to the pass-through panel.
- Install the upper fasteners to the rear compartment.
- Install the lower 2 nuts (3).
- Install the rear compartment front trim panel. Refer to one of
the following procedures: