Removal Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• | Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
• | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
• | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable
the SIR system. Refer to
Disabling the SIR System
in SIR.
- Open the IP storage compartment door.
- Remove the 4 fasteners (2,7)
that retain the IP storage compartment assembly (8) to the instrument
panel.
- Remove the 2 fasteners from inside the instrument panel
storage compartment.
- Partially remove the instrument panel storage compartment assembly (8).
- Disconnect the electrical connectors.
- Remove the instrument panel storage compartment.
Installation Procedure
- Partially install the
instrument panel storage compartment.
- Connect the electrical connectors.
- Install the IP storage compartment assembly (8).
- Install the 2 fasteners to the inside of the instrument
panel storage compartment.
- Install the 4 fasteners (2,7) in order to retain
the IP storage compartment to the IP.
- Close the IP storage compartment door.
- Enable the SIR system. Refer to
Enabling the SIR System
in SIR.