Front Side Door Window Switch Replacement Eldorado

1. Use a 13 mm (0.5 in) wide, flat bladed tool in order to pry up on the rear edge of the trim panel.
2. Insert the blade 19 mm (0.75 in) into the door trim in order to engage the retention clip.
3. Firmly press the blade toward the switch plate (1) in order to disengage the clip.

Notice: The retainer clip must be fully disengaged before the switch plate is removed. Otherwise, damage to the switch plate could result.

4. Pull the flat bladed tool upward while pressing firmly toward the plate.
5. Pull the plate from the trim panel.
6. Disconnect the electrical connectors (2).
7. Remove the switch plate (1).
8. From the back side of the switch plate, gently pry the tabs in order to release the window switch from the switch plate.
9. Remove the switch.

1. Install the switch.
2. Press the switch into the switch plate.



3. Connect the electrical connectors (2).
4. Install the switch plate (1) by evenly setting the plate into the trim panel (3).
5. Press the plate (1) in order to engage the clips on both ends.

Front Side Door Window Switch Replacement DeVille

1. Apply a strip of protective tape in front of the switch trim panel.



2. Use a wide, flat-bladed tool in order to pry up on the front edge of the switch plate.
3. Insert the blade under the switch plate in order to disengage the retention clip.
4. Firmly press the blade toward the front of the switch plate (1,5) and disengage the clip.

Notice: The retainer clip must be fully disengaged before the switch plate is removed. Otherwise, damage to the switch plate could result.

5. Pull the flat-bladed tool upward while pressing firmly toward the plate.
6. Pull the plate from the trim panel.
7. Disconnect the electrical connectors (2) from the driver door switch plate (1). Disconnect the electrical connectors (2) from the passenger door switch plate (5).
8. Remove the switch plate (1, 5).
9. From the back side of the switch plate, gently pry the tabs in order to release the window switch from the switch plate.
10. Remove the switch.

1. Press the window switch into the switch plate (1,5).



2. Connect the electrical connectors (2) to the switch plate (1,5).
3. Install the switch plate (1,5) by evenly setting the plate into the armrest of the trim panel.
4. Press the plate into position in order to engage the clips on both ends.
5. Remove the strip of protective tape.