- Feed the connector through the column and then install the turn signal switch assembly onto the race and upper shaft assembly.
- Install the 3 pan head 6-lobed socket tapping screws (1).
- Lubricate the signal switch arm asembly with synthetic grease. Install the signal switch arm assembly (4).
- Install the flat head tapping screw (3).
- Install the round washer head screw (2).
- Install the upper tilt head components. Refer to Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle
- Remove the hazard knob. Refer to .
- Remove the tilt lever. Refer to .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 9 N·m (80 lb in).
Tighten
Tighten the screw to 2 N·m (20 lb in).
Tighten
Tighten the screw to 4 N·m (31 lb in).
