Tools Required

J 1859-A Steering Wheel Puller

1. Disable the SIR system. Refer to Disabling the SIR System in SIR.
2. Remove the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.



3. Remove the nut that secures the steering column shaft.
4. Use the J 1859-A in order to remove the steering wheel.

1. Feed the coil assembly lead through the slot in the steering wheel.
2. Install the steering wheel to the column shaft.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the nut in order to secure the steering column shaft.

Tighten
Tighten the shaft nut to 41 N·m (30 lb ft).

4. Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement in SIR.
5. Enable the SIR system. Refer to Enabling the SIR System in SIR.